rubber-like 3d printing material

At a Glance


Lead Time





24 hrs (rush)
2 days (standard)

Additional colors available for orders > $1,000
0.16 mm
Simulating overmolds, soft-touch finishing, non-slip surfaces, watertight/ dust-proof seals

About the Material

Rubber-Like is one of the unique printing capabilities of PolyJet machines because of the PhotoPolymer resin used in this style of printing. The prints will give you full flexibility of parts and allow you to simulate rubbers between Shore 27A and Shore 95A. This material, however, will not give you the same elastomeric properties you are used to in rubbers.

Rubber-Like is also great for testing overmolds, as the PolyJet machines can easily print one body in rubber and another in rubber without any seams.

Material Properties

Tensile Strength

Elongation at Break

0.8 MPa (115 PSI)

Material Finish

Design Recommendations

Min Wall Thickness

Min Clearance + Gaps for Fit

Max Part Size (xyz)


1 mm min
0.2 mm offset on each wall is the recommended gap for enclosures.
610 x 813 x 813 mm
24 x 32 x 32 in
+/- 0.004” or +/- 0.001” per inch, whichever is greater

Internal Cavities

Internal cavities are highly discouraged with RubberLike due to the water-based support material that will swell and change the geometry overtime if left inside. Note that support material that has no direct line of sight inside a cavity cannot be cleaned out.

Text Guidelines

Text should be embossed by at least 1.0 mm to stay visible after printing. Text should also be at least 1.5 mm thick in all areas.

Cost Saving Tip

For larger production orders (> 25 units), contact us for volume discount pricing.

Related Resources

Fictiv 3D Printing Material Datasheet
How to Prepare Your Files for Multi-Material 3D Printing